Setup Instructions

Follow these steps to set up your Felx NAS DIY Builder's Kit:

1. Unbox all components and ensure you have everything listed in the included section.
2. Assemble the hardware components according to the wiring map provided in the quick-start guide.
3. Connect the SATA cables from the drives to the SATA controller on the Felx board.
4. Mount the Felx NAS onto the motherboard slot of any ATX case of your choice
5. Install the compatible operating system of your choice.
6. Configure the RAID settings as per your requirements.
7. Connect to your NAS over SSH or the connection method of your choice to complete the setup.